For most coal-fired boilers, the same problem exists, that is, insufficient output.After a comprehensive and detailed analysis, it was determined that the fundamental reason is that the traditional briquette combustion technology has the disadvantage of slow combustion speed, which may cause the boiler's heating surface to corrode quickly and cannot continue to be used.

     In order to avoid the occurrence of the above-mentioned undesirable phenomena, try to choose the furnace type that uses combustion technology when selecting the coal-fired boiler. After continuous improvement and comparison, if the original grate area can burn more than twice in the same time The amount of fuel will be a major innovation to the traditional coal combustion technology, and this is the so-called enhanced combustion technology of coal.

    Under the briquette enhanced combustion technology, the high-temperature flue gas generated in the furnace of the coal-fired boiler passes through the raw coal layer that has just entered the furnace from top to bottom, so that the raw coal that has just entered the furnace can complete the water analysis in a relatively short time. The volatile matter precipitates out and reaches the ignition temperature relatively quickly and starts to burn.

     Therefore, as far as the grate of the coal-fired boiler is viewed from front to back along the length, the ignition point of the briquette after the use of enhanced combustion technology is greatly advanced, the burning degree of the briquette will be greatly improved, and the carbon content of the ash will be reduced a lot of.It also provides a time guarantee for the slag that is close to the burning slag to stay in the furnace for a longer time to reduce the heat taken away by the slag.

    Tests have proved that after adopting briquette-enhanced combustion technology in coal-fired boilers, the amount of coal burned is twice that of traditional briquette combustion methods on the same grate area and within the same time under the premise of ensuring the burning of ashes. the above.However, attention should also be paid to solving the problems of reliable cooling of the grate slices and the burning of the volatile matter precipitated by the raw coal into the furnace.