Since realizing that traditional boiler equipment is not ideal in terms of energy saving and environmental protection, we have been researching and transforming it, and finally achieved good results.As long as the boiler is slightly improved, it can make it convenient for energy-saving and environmentally-friendly boilers and show advantages in all aspects.

    First of all, the preheater of the boiler can be modified using sealing technology. Practice has proved that this can indeed reduce a lot of air leakage rate, while reducing the power consumption of the fan, increasing the efficiency of the boiler to a certain extent, and prolonging its service life.

    Secondly, the top of the boiler burner is reverse-cut processing, and the top seal is directly transformed into a reverse-cut air nozzle with a reverse-tangent angle of 22°. The intensity of the outlet flue gas swirl is reduced to avoid pipe bursts and smoke acceleration caused by excessive temperature. The heating surface is worn out, and the desuperheating water can be greatly reduced.

    In addition, the renovation of the boiler's primary fan inlet heater is still part of the energy-saving and environmental protection renovation plan. The traditional fan inlet heater is beneficial to avoid corrosion, serious leakage, and failure to operate normally, which may easily lead to accumulation of heat transfer fins of the boiler gas preheater Impurities and low-temperature corrosion will reduce boiler efficiency.After the modification and replacement, the inlet temperature of the air preheater can be increased to a certain value, and normal operation can be achieved.

    There is another aspect that cannot be ignored, that is, the maintenance procedures in all aspects of the boiler should be strengthened, and a variety of technologies should be used for transformation, so that the problem of valve leakage can be completely solved and various failures caused by this should be reduced.

    After the above-mentioned effective transformation measures, not only the consumption capacity of the boiler is reduced, and the waste of funds is reduced, but also the technical level of the equipment is improved, which is of great significance in enhancing the performance and life of the equipment.