Materials Managing Energy UNIT two
This energy unit capabilities energy up gravity down circuit. Activate the get started solenoid to start the motor to lift the machine. The lowing motion is activated by the solenoid valve using the lowering velocity controlled through the stress compensated movement management valve. Merchandise of this series is usually widely utilized in the marketplace of logistic units which include fork lift, mini lift table, and so on.
one. The duty of this electrical power unit is S3,i.e.,30 seconds on and 270 senconds off.
two. Clean the many hydraulic parts concerned in advance of mounting the energy unit.
3. Viscosity in the hydraulic oil shoud be 15~46 cst,which must also be clean and cost-free of impurities, N46 hydraulic oil is suggested .
4. Oil modifying is needed right after the preliminary one hundred operation hours,afterwards when each 3000 hrs.
5. The electrical power unit need to be mounted horizontally.
Materials Dealing with Electrical power UNIT one
This energy unit is built to the fork lift sector, consisting of extremely efficient gear pump, DC motor, guide increase and lower valve, tank, ect. The up and down motion are controlled through the lever from the guide release valve, that’s outfitted with an electric switch to activate the motor. The lowing pace is managed through the pressure compensated movement control valve.
1. The duty of this power unit is S3, i.e. thirty seconds on and 270 senconds off.
two. Clean all the hydraulic components concerned prior to set up of the power unit.
three. Viscosity from the hydraulic oil shoud be 15~46 cst, which really should also be clean and no cost of impurities, N46 hydraulic oil is suggested .
4. Oil altering is needed immediately after the original a hundred operation hrs, afterwards when each and every 3000 hrs.
5. The energy unit shown is intended to be mounted horizontally.