Energy UNITS FOR LIFT TABLE one
General Description
This power unit is made solely for the tiny lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This power unit has been widely utilized within the field of logistic devices like minifork lift, scissors lift and ariel functioning platforms. The lower-ing movement is controlled from the solenoid valve with the speed controlled from the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
Basic Description
This power unit is designed solely for your medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve and also the speed controlled from the adjustable needle valve. Once the lift rises to a substantial positoin, but the electrical power supply is minimize, the lowering motion is controlled by the manual override function.
Energy UNITS FOR LIFT TABLE three
Basic Description
This electrical power unit is built solely for the big lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve as well as the speed managed by a strain compensated movement handle valve.
Power UNITS FOR LIFT TABLE 4
General Description
This energy unit is made solely for your massive lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve as well as the speed controlled from the adjustable needle valve. Once the lift rises to a higher positoin, but the electrical power supply is cut, the decreasing motion is controlled through the guide override function.
Exclusive Notes
one. This energy unit is of S3 duty cycle, which might only perform intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean all the hydraulic components concerned just before installation of the energy unit.
3. Viscosity from the oil shoud be 15~46 cst,which really should also be clean and cost-free of impurities.N46 hydraulic oil is advisable.
4. Oil shifting is needed after the first 100 operation hours,afterwards once each 3000 hours.
five. The power unit shown is made to be mounted vertically.
Electrical power UNITS FOR LIFT TABLE
Tags