DUMP TRAILER Electrical power UNIT-DOUBLE ACTING
General Description
This energy unit features a power up electrical power down circuit with load holding on the two A & B ports. A stress compensatred flow management is usually additional to circuit to manage the decent speed from the cylinder.
Special Notes
one. This electrical power unit is of S3 duty cycle, i.e., non-continuous operation, thirty seconds on and 270 seconds off.
two. Clean the many hydraulic components concerned just before set up of the power unit.
3. Viscosity in the hydraulic oil shoud be 15~46 cst, which really should also be clean and absolutely free of impurities. N46 hydraulic oil is proposed.
four. The power unit needs to be mounted horizontally.
5. Check the oil level while in the tank immediately after the initial operating with the electrical power unit.
six. Oil shifting is needed right after the preliminary a hundred operation hours, afterwards as soon as just about every 3000 hours.
DUMP TRAILER Electrical power UNIT- SINGLE ACTING
Common Description
This energy unit has a energy up gravity down circuit. Start out 
the motor to lengthen the cylinder and activate the solenoid valve to retract the circuit. Manual override to solenoid valve is often provided if demanded. Also a pressure compen sated flow control may be additional to your circuit to control the descent speed from the cylinder.
Remark: Please check with our product sales engineer for the various pump displacement, motor electrical power or tank capacity.
Particular Notes
one. This power unit is of S3 duty cycle, i.e., non-continuous operation, thirty seconds on and 270 seconds off.
two. Clean the many hydraulic parts concerned in advance of set up of the electrical power unit.
three. Viscosity from the hydraulic oil shoud be 15~46 cst,which really should also be clean and absolutely free of impurities.N46 hydraulic oil is recommended.
four. The electrical power unit really should be mounted horizontally.
5. Check the oil degree inside the tank following the original working of the electrical power unit.
six. Oil changing is required just after the original one hundred operation hrs, afterwards once each 3000 hrs.